Wall Paints

Home Fresco Matt
SIRCA FRESCO MATT is the best Matt finish available in the market today. When applied on walls, it provides a smooth matt finish with an elegant appeal.

PLASTER The masonry surface to work on should be treated and well cured for the process of Sirca Fresco Matt Finish. Better to allow a gap of 28 days before the process.

CLEANING Surface should be free from any loose paint, dust or grease. Growth of fungus, algae or moss should be removed by wire brushing and water. In case of areas having excessive dampness use SIRCA Paints Damp Block to stop further dampness. Even after cleaning if the surface shows chalkiness, use SIRCA Paints Exterior Sealer to get an even surface.

FILLING FOR CRACKS 3mm SIRCA Paints Crack Seal could be used for the fillers.

FILLING FOR HOLES & DENTS In case of dents and holes use SIRCA Paints Acrylic Wall Putty or white cement and fine sand in the ratio 1:3. SIRCA FRESCO MATT should not be applied on surfaces/substrates that are subjected to continuous seepage or dampness.

  • The Golden rule for removing any wall stains is that one should remove it immediately.
  • Remove all dirt using a clean cloth or duster. Always remove dirt from top to bottom, this helps in avoiding loose dirt to smudge the walls.
  • For regular household stains like pencil, tea, coffee, crayons etc, use 5% soap/ detergent solution. Use a sponge to remove the stains.
  • In case of tough stains like turmeric, sketch pen, use a mild detergent solution (e.g Pril, Vim Liquid etc) for cleaning the stains.

  • Do not apply when ambient temperature is less than 10°C or if the temperature might drop to this level within 4 hrs of application.
  • Do not over-thin or over-extend the brush.
  • Tint using machine colourants only.
  • Stir well and strain before use.
  • Tinted paints need thorough shaking immediately after tinter addition as well as before use.
  • For best performance ensure that the surface is dry. On moisture meter it should be under the green zone. In case it is in Red zone, find out the source of water and address it before painting.
  • For better washability ensure the paint surface is cured for 2 weeks under normal atmospheric conditions. (30º.C. ; 50 – 60 %RH)
  • Application of SIRCA Paints Acrylic Wall Putty and adherence to the painting system will lead to best results.